NETGEAR ProSAFE SRX5308 - Chapter 4 Security Mode Configuration Commands; Security Services Commands

101
4
4. Security Mode Configuration
Commands
This chapter explains the configuration commands, keywords, and associated parameters in the
security mode. The chapter includes the following sections:
• Security Services Commands
• Security Schedules Commands
• IPv4 Add Firewall Rule and Edit Firewall Rule Commands
• IPv4 General Firewall Commands
• IPv6 Firewall Commands
• Attack Check Commands
• Session Limit, Time-Out, and Advanced Commands
• Address Filter and IP/MAC Binding Commands
• Port Triggering Commands
• UPnP Command
• Bandwidth Profile Commands
• Content Filtering Commands
IMPORTANT:
After you have issued a command that includes the word
configure, add, or edit, you need to save (or cancel) your
changes. For more information, see Save Commands on page 12.
Security Services Commands
security services add
This command configures a new firewall custom service. After you have issued the
security services add command, you enter the security-config [custom-service] mode,
and then you can configure one keyword and associated parameter or associated keyword
at a time in the order that you prefer.