NETGEAR ProSAFE SRX5308 - Ipv4 DMZ Setup Commands

Net Mode Configuration Commands
74
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net lan ipv6 prefix_delegation delete <row id>
This command deletes an IPv6 prefix for LAN prefix delegation by deleting its row ID.
Related show command: show net lan ipv6 setup
IPv4 DMZ Setup Commands
net dmz ipv4 configure
This command enables, configures, or disables the IPv4 DMZ. After you have issued the net
dmz ipv4 configure command, you enter the net-config [dmz-ipv4] mode, and then you
can configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
Format net lan ipv6 prefix_delegation delete <row id>
Mode net
Step 1 Format net dmz ipv4 configure
Mode net
Step 2 Format enable_dmz {Y | N}
ip_address <ipaddress>
subnet_mask <subnet mask>
dhcp_mode {None | DHCP-Server | DHCP-Relay}
dns_proxy_enable {Y | N}
domain_name <domain name>
starting_ip_address <ipaddress>
ending_ip_address <ipaddress>
primary_dns_server <ipaddress>
secondary_dns_server <ipaddress>
wins_server <ipaddress>
lease_time <hours>
enable_ldap {Y | N}
ldap_serverip <ipaddress>
ldap_search_base <search base>
ldap_port <number>
relay_gateway <ipaddress>
Mode net-config [dmz-ipv4]