NETGEAR ProSAFE SRX5308 - Security Services Qos_Profile Add

Security Mode Configuration Commands
103
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Related show command: show security services setup
security services delete <row id>
This command deletes a custom security service by deleting its row ID.
Related show command: show security services setup
security services qos_profile add
This command configures a new Quality of Service (QoS) profile that you can associate with
a nonblocking inbound or outbound IPv4 firewall rule. After you have issued the security
services qos_profile add command, you enter the security-config [qosProfile] mode,
and then you can configure one keyword and associated parameter or associated keyword at
a time in the order that you prefer.
Step 2 Format protocol {TCP {start_port <number>} {finish_port <number>} |
UDP {start_port <number>} {finish_port <number>} |
ICMP {icmp_type <number> | ICMPv6 {icmp_type <number>}}
Mode security-config [custom-service]
Keyword Associated Keyword to
Select or Parameter to Type
Description
protocol TCP, UDP, ICMP, or ICMPv6 Specifies the protocol type that applies to the service.
start_port number For TCP and UDP, the start port number (integer) of the
range used by the destination user. Valid numbers are from
1 to 65535.
finish_port number For TCP and UDP, the end port number (integer) of the
range used by the destination user. Valid numbers are from
1 to 65535.
icmp_type number The ICMP type (integer) used by the destination user.
Format security services delete <row id>
Mode security
Step 1 Format security services qos_profile add
Mode security