NETGEAR ProSAFE SRX5308 - Util Ping_Through_Vpn_Tunnel; Util Traceroute; Util Routing_Table_Ipv

Utility Commands
324
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
util ping_through_vpn_tunnel
This command pings a VPN endpoint IP address with 56 data bytes through a VPN tunnel
and displays the ping information.
SRX5308> util ping_through_vpn_tunnel 10.136.24.128
Pinging 192.168.1.1 from 5
Ping passed
64 bytes from 10.136.24.128: icmp_seq=0 ttl=64
64 bytes from 10.136.24.128: icmp_seq=1 ttl=64
64 bytes from 10.136.24.128: icmp_seq=2 ttl=64
64 bytes from 10.136.24.128: icmp_seq=3 ttl=64
64 bytes from 10.136.24.128: icmp_seq=4 ttl=64
util traceroute
This command traces a route to an IP address.
SRX5308> util traceroute 10.136.24.128
traceroute to 10.136.24.128 (10.136.24.128), 30 hops max, 40 byte packets|
1 (10.136.24.128) 0.516 ms 0.227 ms 0.218 ms
util routing_table_ipv4
This command displays the IPv4 routing table.
util routing_table_ipv6
This command displays the IPv6 routing table.
Format util ping_through_vpn_tunnel <ipaddress>
Mode util
Format util traceroute <ipaddress>
Mode util
Format util routing_table_ipv4
Mode util
Format util routing_table_ipv6
Mode util