NETGEAR ProSAFE SRX5308 - Security Settings (Security Mode) Configuration Commands

Overview of the Configuration Commands
20
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Security Settings (Security Mode) Configuration
Commands
Enter the security ? command at the CLI prompt to display the submodes in the security
mode. The following table lists the submodes and their commands in alphabetical order:
wan
net wan port_setup configure <wan interface> Configure the MTU, port speed, and MAC
address of the VPN firewall.
net wan wan ipv4 configure <wan interface> Configure the IPv4 settings of the WAN
interface.
net wan wan ipv4 secondary_address add
<wan interface>
Configure a secondary IPv4 WAN address.
net wan wan ipv4 secondary_address delete
<row id>
Delete a secondary IPv4 WAN address.
net wan wan ipv6 configure <wan interface> Configure the IPv6 settings of the WAN
interface.
wan_settings
net wan_settings load_balancing configure Configure the load balancing settings for two
WAN interfaces that are configured for IPv4.
net wan_settings wanmode configure Configure the mode of IPv4 routing (NAT or
classical routing) between the WAN interface
and LAN interfaces.
Table 8. Security mode configuration commands
Submode Command Name Purpose
address_filter
security address_filter ip_or_mac_binding add Configure a new IP/MAC binding rule.
security address_filter ip_or_mac_binding
delete <row id>
Delete an IP/MAC binding rule.
security address_filter ip_or_mac_binding edit
<row id>
Configure an existing IP/MAC binding
rule.
security address_filter ip_or_mac_binding
enable_email_log <ip version>
Configure the email log for IP/MAC
Binding violations.
security address_filter mac_filter configure Configure the source MAC address filter.
security address_filter mac_filter source add Configure a new MAC source address.
security address_filter mac_filter source delete
<row id>
Delete a MAC source address.
Table 7. Net mode configuration commands (continued)
Submode Command Name Purpose