NETGEAR ProSAFE SRX5308 - Chapter 7 Overview of the Show Commands; Network Settings (Net Mode) Show Commands

267
7
7. Overview of the Show Commands
This chapter provides an overview of all show commands for the four configuration command
modes. The chapter includes the following sections:
• Network Settings (Net Mode) Show Commands
• Security Settings (Security Mode) Show Commands
• Administrative and Monitoring Settings (System Mode) Show Commands
• VPN Settings (VPN Mode) Show Commands
Network Settings (Net Mode) Show Commands
Enter the show net ? command at the CLI prompt to display the submodes in the show net
mode. The following table lists the submodes and their commands in alphabetical order:
Table 12. Show commands: show net mode
Submode Command Name Purpose
ddns show net ddns setup Display the Dynamic DNS configuration.
dmz show net dmz ipv4 setup Display the IPv4 DMZ configuration.
show net dmz ipv6 setup Display the IPv6 DMZ configuration.
ethernet show net ethernet {interface name | all} Display the MAC address and VLAN status for a
single or all Ethernet interfaces.
ipv6 show net ipv6 ipmode setup Display the IPv6 routing mode configuration.
ipv6_tunnel
show net ipv6_tunnel setup Display the IPv6 tunnel configuration.
show net ipv6_tunnel status Display the status of the IPv6 tunnels.
lan
show net lan available_lan_hosts list Display the IPv4 hosts.
show net lan dhcp leased_clients list Display the LAN clients that received a leased
DHCP IP address.
show net lan dhcp logs Display the LAN DHCP log.