NETGEAR ProSAFE SRX5308 - WAN Traffic Meter Command

System Mode Configuration Commands
198
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
WAN Traffic Meter Command
system traffic_meter configure <wan interface>
This command configures the traffic meter. After you have issued the system
traffic_meter configure command to specify one of the four WAN interfaces (that is,
WAN1, WAN2, WAN3, or WAN4), you enter the system-config [traffic-meter] mode, and then
you can configure one keyword and associated parameter or associated keyword at a time in
the order that you prefer.
Step 1 Format system traffic_meter configure {WAN1 | WAN2 | WAN3 | WAN4}
Mode system
Step 2 Format enable {Y | N}
limit_type {Nolimit | Downloadonly | Directions}
monthly_limit <number>
increase_limit_enable {N | Y {increase_limit_by <number>}}
counter {RestartCounter | SpecificTime {day_of_month <day>}
{time_hour <hour>} {time_meridian {AM | PM}} {time_minute
<minute>}}
send_email_report {Y | N}
block_type {Block-all-traffic | Block-all-traffic-except-email}
send_email_alert {Y | N}
Mode system-config [traffic-meter]
Keyword Associated Keyword to Select or
Parameter to Type
Description
Traffic meter configuration
enable Y or N Enables or disables the traffic meter.
limit_type Nolimit, Downloadonly, or
Directions
Specifies the type of traffic limit, if any:
• Nolimit. There is no traffic limit.
• Downloadonly. The traffic limit
applies to downloaded traffic only.
• Directions. The traffic limit applies
to both downloaded and uploaded
traffic.
monthly_limit number The monthly limit for the traffic meter
in MB.