NETGEAR ProSAFE SRX5308 - Ipv4 General Firewall Commands

Security Mode Configuration Commands
154
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
IPv4 General Firewall Commands
security firewall ipv4 default_outbound_policy {Allow | Block}
This command allows or blocks the IPv4 firewall default outbound policy.
Related show command: show security firewall ipv4 setup lan_wan, show security firewall ipv4 setup
dmz_wan, and show security firewall ipv4 setup lan_dmz
security firewall ipv4 delete <row id>
This command deletes an IPv4 firewall rule by deleting its row ID.
Related show command: show security firewall ipv4 setup lan_wan, show security firewall ipv4 setup
dmz_wan, and show security firewall ipv4 setup lan_dmz
security firewall ipv4 disable <row id>
This command disables an IPv4 firewall rule by specifying its row ID.
Related show command: show security firewall ipv4 setup lan_wan, show security firewall ipv4 setup
dmz_wan, and show security firewall ipv4 setup lan_dmz
security firewall ipv4 enable <row id>
This command enables an IPv4 firewall rule by specifying its row ID.
Format security firewall ipv4 default_outbound_policy {Allow | Block}
Mode security
Format security firewall ipv4 delete <row id>
Mode security
Format security firewall ipv4 disable <row id>
Mode security
Format security firewall ipv4 enable <row id>
Mode security