NETGEAR ProSAFE SRX5308 - WAN Qos Commands

Net Mode Configuration Commands
80
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
SRX5308> net radvd configure dmz
net-config[radvd-dmz]> enable Y
net-config[radvd-dmz]> mode Unicast-Only
net-config[radvd-dmz]> flags Managed
net-config[radvd-dmz]> preference High
net-config[radvd-dmz]> mtu 1500
net-config[radvd-dmz]> life_time 7200
net-config[radvd-dmz]> save
Related show command: show net radvd dmz setup
WAN QoS Commands
net qos configure
This command configures the QoS mode for the WAN interfaces. After you have issued the
net qos configure command, you enter the net-config [network-qos] mode, and then you
can enable QoS and set the QoS mode to rate control or priority.
The configured QoS mode determines which WAN QoS profiles can be active, that is, you
can add both rate control or priority WAN QoS profiles (see the net qos profile add
command), but only the profiles for the configured QoS mode can be active. For example, if
you set the QoS mode to priority, then only the profiles with a priority configuration can be
active.
Related show command: show net qos setup
Step 1 Format net qos configure
Mode net
Step 2 Format enable {Y | N}
qos_type {Rate-Control | Priority}
Mode net-config [network-qos]
Keyword Associated
Keyword to Select
Description
enable Y or N Enables or disables QoS for all WAN interfaces.
qos_type Rate-Control or
Priority
Specifies whether QoS uses rate control or priority profiles.