NETGEAR ProSAFE SRX5308 - Ipv6 DMZ Setup Commands

Net Mode Configuration Commands
76
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net-config[dmz-ipv4]> ip_address 10.126.32.59
net-config[dmz-ipv4]> subnet_mask 2525.255.255.0
net-config[dmz-ipv4]> dhcp_mode None
net-config[dmz-ipv4]> dns_proxy_enable Y
net-config[dmz-ipv4]> save
Related show command: show net dmz ipv4 setup
IPv6 DMZ Setup Commands
net dmz ipv6 configure
This command enables, configures, or disables the IPv6 DMZ. After you have issued the net
dmz ipv6 configure command, you enter the net-config [dmz-ipv6] mode, and then you
can configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
Step 1 Format net dmz ipv6 configure
Mode net
Step 2 Format enable_dmz {Y | N}
ip_address <ipv6-address>
prefix_length <prefix length>
dhcp_enable {N | Y {dhcp_mode {Stateless | Stateful}}}
domain name <domain-name>
server_preference <number>
dns_server_option {useDnsProxy | useDnsFromISP | useEnteredDns
{primary_dns_server <ipv6-address>} [secondary_dns_server
<ipv6-address>]}
lease_time <seconds>
Mode net-config [dmz-ipv6]
Keyword Associated Keyword to
Select or Parameter to Type
Description
enable_dmz Y or N Enables or disables the DMZ.
ip_address ipv6-address The IPv6 address of the DMZ port.
prefix_length prefix length The prefix length (integer) for the DMZ port.