NETGEAR ProSAFE SRX5308 - Security Services Ip_Group Add

Security Mode Configuration Commands
107
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Related show command: show security services qos_profile setup
security services qos_profile delete <row id>
This command deletes a QoS profile by deleting its row ID.
Related show command: show security services qos_profile setup
security services ip_group add
This command configures a new LAN or WAN IP group. After you have issued the security
services ip_group add command, you enter the security-config [ipGroup] mode, and
then you can configure the group type and name in the order that you prefer.
qos_priority Default, High,
Medium-high, Medium,
or Low
Specifies the priority queue that
determines the allocation of excess
bandwidth and the classification level of
the packets among other priority queues
on the VPN firewall:
• Default. Traffic is mapped based on the
ToS field in the packet’s IP header.
• High. This queue includes the following
DSCP values: AF41, AF42, AF43, AF44,
and CS4.
• Medium-high. This queue includes the
following DSCP values: AF31, AF32,
AF33, AF34, and CS3.
• Medium. This queue includes the
following DSCP values: AF21, AF22,
AF23, AF24, and CS2.
• Low. This queue includes the following
DSCP values: AF11, AF12, AF13, AF14,
CS1, 0, and all other values.
Format security services qos_profile delete <row id>
Mode security
Step 1 Format security services ip_group add
Mode security
Keyword (might consist of two
separate words)
Associated Keyword to
Select or Parameter to Type
Description