NETGEAR ProSAFE SRX5308 - L2 TP Server Commands; Vpn L2 Tp Server Configure

VPN Mode Configuration Commands
266
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
L2TP Server Commands
vpn l2tp server configure
This command configures the L2TP server. After you have issued the vpn l2tp server
configure command, you enter the vpn-config [l2tp-config] mode, and then you can
configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
Command example:
SRX5308> vpn l2tp server configure
vpn-config[l2tp-config]> enable Y
vpn-config[l2tp-config]> start_address 192.168.112.1
vpn-config[l2tp-config]> end_address 192.168.112.25
vpn-config[l2tp-config]> idle_timeout 10
vpn-config[l2tp-config]> save
Related show command: show vpn l2tp server setup and show vpn l2tp server connections
Step 1 Format vpn l2tp server configure
Mode vpn
Step 2 Format enable {Y | N}
start_address <ipaddress>
end_address <ipaddress>
idle_timeout <minutes>
Mode vpn-config [l2tp-config]
Keyword Associated Keyword to
Select or Parameter to Type
Description
enable Y or N Enables or disables the L2TP server.
start_address ipaddress The start IPv4 address of the L2TP server range.
end_address ipaddress The end IPv4 address of the L2TP server range.
idle_timeout minutes The idle time-out after which the connection is terminated.