NETGEAR ProSAFE SRX5308 - Dynamic DNS Commands

Net Mode Configuration Commands
53
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
FVS318N> net ipv6_tunnel six_to_four configure
net-config[six-to-four-tunnel]> automatic_tunneling_enable Y
net-config[six-to-four-tunnel]> save
Related show commands: show net ipv6_tunnel setup and show net ipv6_tunnel status
Dynamic DNS Commands
net ddns configure
This command enables, configures, or disables Dynamic DNS (DDNS) service. After you
have issued the net ddns configure command, you enter the net-config [ddns] mode,
and then you can configure one keyword and associated parameter or associated keyword at
a time in the order that you prefer. Before you specify a keyword, you need to specify the
WAN interface to which the configuration applies.
Keyword Associated Keyword
to Select
Description
automatic_tunneling_enable Y or N Enables or disables automatic tunneling.
Step 1 Format net ddns configure
Mode net
Step 2 Format {wan1 | wan2 | wan3 | wan4} enable {Disable | DynDNS | TZO |
DNS_Oray | 3322_DDNS}
{wan1 | wan2 | wan3 | wan4} hostname <host name>
{wan1 | wan2 | wan3 | wan4} username <user name>
{wan1 | wan2 | wan3 | wan4} password <password>
{wan1 | wan2 | wan3 | wan4} wild_flag_enable {Y | N}
{wan1 | wan2 | wan3 | wan4} time_update_enable {Y | N}
Mode net-config [ddns]
Keyword (might consist of two
separate words)
Associated Keyword to
Select or Parameter to Type
Description
{wan1 | wan2 | wan3 | wan4}
enable
Disable, DynDNS, TZO,
DNS_Oray, or 3322_DDNS
Specifies whether DDNS is disabled or
enabled with a particular service. Use the
Disable keyword to disable DDNS after
you had first enabled the service. The
other keywords represent DDNS service
providers and are self-explanatory.
{wan1 | wan2 | wan3 | wan4}
hostname
host name Configures a host name (string) for a
DDNS server.