NETGEAR ProSAFE SRX5308 - Ipv4 WAN Commands

Net Mode Configuration Commands
31
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net-config[port_setup]> upload_download download_speed_type 1-Gbps
net-config[port_setup]> save
Related show command: show net wan port_setup <wan interface>
IPv4 WAN Commands
net wan_settings wanmode configure
This command configures the mode of IPv4 routing between the WAN interface and LAN
interfaces. After you have issued the net wan_settings wanmode configure
command, you enter the net-config [routing-mode] mode, and then you can configure NAT or
classical routing.
WARNING!
Changing the mode of IPv4 routing causes all LAN–WAN and
DMZ–WAN inbound firewall settings to revert to default settings.
Command example:
FVS318N> net wan_settings wanmode configure
net-config[routing-mode]> NAT
net-config[routing-mode]> save
Related show command: show net wan_settings wanmode
Step 1 Format net wan_settings wanmode configure
Mode net
Step 2 Format type {NAT | Classical_Routing}
Mode net-config [routing-mode]
Keyword Associated Keyword
to Select
Description
type NAT or
Classical_Routing
Specifies the IPv4 routing mode.