NETGEAR ProSAFE SRX5308 - Manage Users, Authentication, and VPN Certificates

Show Commands
301
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Note: The VPN logs and RADIUS logs are part of the VPN Mode show
commands (see VPN Settings (VPN Mode) Show Commands on
page 311).
Remote Management Show Command
show system remote_management setup
This command displays the configuration of remote management for Telnet and HTTPS
access:
Remote Mgmt Configuration for telnet
____________________________________
IPv4 access granted to everyone
IPv6 access granted to a range of IPs from : FEC0::3001 to FEC0::3100
port being used : 23
Remote Mgmt Configuration for https
___________________________________
IPv4 access granted to everyone
IPv6 access granted to everyone
port being used : 445
SNMP Show Commands
show system snmp trap [agent ipaddress]
This command displays the SNMP trap configuration of an SNMP agent:
Trap Agent IP Address
_____________________
IP Address: 10.118.33.245
Subnet Mask: 255.255.255.0
Port: 162
Community: public