NETGEAR ProSAFE SRX5308 - Global Commands

Introduction
13
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Commands That Require Saving
After you have issued a command that includes the word configure, add, or edit, you
enter a configuration mode from which you can issue keywords and associated parameters.
These are examples of commands for which you need to save your changes:
• net lan ipv4 configure <vlan id> lets you enter the net-config [lan-ipv4]
configuration mode. After you made your changes, issue save or exit to save your
changes.
• security content_filter trusted_domain add lets you enter the
security-config [approved-urls] configuration mode. After you made your changes, issue
save or exit to save your changes.
• vpn sslvpn users groups add lets you enter the vpn-config [user-groups]
configuration mode. After you made your changes, issue save or exit to save your
changes.
Commands That Do Not Require Saving
You do not need to save your changes after you have issued a command that deletes,
disables, or enables a row ID, name, IP address, or MAC address, or that lets you make a
configuration change without entering another configuration mode.
These are examples of commands that you do not need to save:
• net lan dhcp reserved_ip delete <mac address>
• vpn ipsec vpnpolicy disable <vpn policy name>
• security firewall ipv4 enable <row id>
• security firewall ipv4 default_outbound_policy {Allow | Block}
Global Commands
The following table describes the global commands that you can use anywhere in the CLI.
These commands need to be preceded by a period.
Table 5. Global CLI commands
Command Description
.exit Exit the current session.
.help Display an overview of the CLI syntax.
.top Return to the default command mode or root.
.reboot Reboot the system.
.history Display the command-line history of the current session.