NETGEAR ProSAFE SRX5308 - Chapter 2 Overview of the Configuration Commands; Network Settings (Net Mode) Configuration Commands

17
2
2. Overview of the Configuration
Commands
This chapter provides an overview of all configuration commands in the four configuration
command modes. The keywords and associated parameters that are available for these
commands are explained in the following chapters. The chapter includes the following sections:
• Network Settings (Net Mode) Configuration Commands
• Security Settings (Security Mode) Configuration Commands
• Administrative and Monitoring Settings (System Mode) Configuration Commands
• VPN Settings (VPN Mode) Configuration Commands
Network Settings (Net Mode) Configuration Commands
Enter the net ? command at the CLI prompt to display the submodes in the net mode. The
following table lists the submodes and their commands in alphabetical order:
Table 7. Net mode configuration commands
Submode Command Name Purpose
ddns
net ddns configure Enable, configure, or disable DDNS service.
dmz
net dmz ipv4 configure Enable, configure, or disable the IPv4 DMZ.
net dmz ipv6 configure Enable, configure, or disable the IPv6 DMZ.
net dmz ipv6 pool configure <ipv6 address> Configure a new or existing IPv6 DMZ DHCP
address pool.
net dmz pool ipv6 delete < ipv6 address> Delete an IPv6 DMZ DHCP address pool.
ethernet
net ethernet configure <interface name or
number>
Configure a VLAN for a LAN interface.
ipv6
net ipv6 ipmode configure Configure the IP mode (IPv4 only or
IPv4/IPv6).
ipv6_tunnel
net ipv6_tunnel isatap add Configure a new IPv6 ISATAP tunnel.
net ipv6_tunnel isatap delete <row id> Delete an IPv6 ISATAP tunnel.