NETGEAR ProSAFE SRX5308 - Ipv6 Tunnel Commands

Net Mode Configuration Commands
50
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Related show commands: show net wan wan ipv6 setup <wan interface> and show net wan wan
ipv6 status <wan interface>
net siit configure
This command enables and configures Stateless IP/ICMP Translation (SIIT). After you have
issued the net siit configure command, you enter the net-config [siit] mode, and then
you can enable SIIT and configure the IPv4 address.
Command example:
SRX5308> net siit configure
net-config[siit]> enable Y
net-config[siit]> ipv4_address 192.168.5.117
net-config[siit]> save
Related show command: show net siit setup
IPv6 Tunnel Commands
net ipv6_tunnel isatap add
This command configures a new ISATAP tunnel. After you have issued the net
ipv6_tunnel isatap add command, you enter the net-config [isatap-tunnel] mode, and
then you can configure one keyword and associated parameter or associated keyword at a
time in the order that you prefer.
Step 1 Format net siit configure
Mode net
Step 2 Format enable {Y | N}
ipv4_address <ipaddress>
Mode net-config [siit]
Keyword Associated Keyword to
Select or Parameter to Type
Description
enable Y or N Enables or disables SIIT.
ipv4_address subnet mask The IPv4 address for the SIIT configuration.