NETGEAR ProSAFE SRX5308 - VPN Settings (VPN Mode) Show Commands

Overview of the Show Commands
271
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
VPN Settings (VPN Mode) Show Commands
Enter the show vpn ? command at the CLI prompt to display the submodes in the show vpn
mode. The following table lists the submodes and their commands in alphabetical order:
remote_management show system remote_management setup Display the configuration of remote
management for Telnet and HTTPS access.
snmp
show system snmp sys Display the SNMP system configuration of
the SNMP agent and the SNMP system
information of the wireless VPN firewall.
show system snmp trap [agent ipaddress] Display the SNMP trap configuration of the
SNMP agent.
status show system status Display the system status information.
time show system time setup Display the time configuration and the
configuration of the NTP server.
traffic_meter show system traffic_meter setup
<wan interface>
Display the configuration of the traffic meter
and the Internet traffic statistics.
Table 15. Show commands: show vpn mode
Submode Command Name Purpose
ipsec
show vpn ipsec ikepolicy setup Display the IKE policies.
show vpn ipsec logs Display the IPSec VPN logs.
show vpn ipsec mode_config setup Display the Mode Config records.
show vpn ipsec radius [ipaddress] Display the configuration of all or a specific
RADIUS server.
show vpn ipsec vpnpolicy setup Display the IPSec VPN policies.
show vpn ipsec vpnpolicy status Display status information about the active
and nonactive IPSec VPN policies.
l2tp
show vpn l2tp server connections Display the users that are connected through
the L2TP server.
show vpn l2tp server setup Display the configuration of the PPTP server.
pptp
show vpn pptp server connections Display the users that are connected through
the PPTP server.
show vpn pptp server setup Display the configuration of the L2TP server.
Table 14. Show commands: show system mode (continued)
Submode Command Name Purpose