321
9
9. Utility Commands
This chapter explains the configuration commands, keywords, and associated parameters in the
Util mode. The chapter includes the following sections:
• Overview Util Commands
• Firmware Backup, Restore, and Upgrade Commands
• Diagnostic Commands
Overview Util Commands
Enter the util ? command at the CLI prompt to display the utility commands in the util
mode. The following table lists the commands in alphabetical order:
Table 16. Utility commands in the util mode
Command Name Purpose
util backup_configuration Back up the configuration file of the VPN firewall to a TFTP
server.
util dns_lookup Look up the IP address of a domain name.
util firmware_upgrade Upgrade the firmware of the VPN firewall from a TFTP server.
util ping Ping an IP address.
util ping_through_vpn_tunnel Ping a VPN endpoint IP address.
util reboot Reboot the VPN firewall.
util restore_factory_defaults Restore the VPN firewall to factory default settings.
util routing_table_ipv4 Display the IPv4 routing table.
util routing_table_ipv6 Display the IPv6 routing table.
util traceroute Trace a route to an IP address.
util upload_configuration Upload a previously backed-up configuration file of the VPN
firewall from a TFTP server
To Next Page
Loading...
