NETGEAR ProSAFE SRX5308 - Administrative and Monitoring Settings (System Mode) Configuration Commands

Overview of the Configuration Commands
23
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Administrative and Monitoring Settings (System Mode)
Configuration Commands
Enter the system ? command at the CLI prompt to display the submodes in the system
mode. The following table lists the submodes and their commands in alphabetical order:
schedules
security schedules edit {1 | 2 | 3} Configure one of the three security
schedules.
services
security services add Configure a new custom service.
security services delete <row id> Delete a custom service.
security services edit <row id> Configure an existing custom service.
security services ip_group add Configure a new LAN or WAN IP group.
security services ip_group add_ip_to
<group name>
Add an IP address to a LAN or WAN IP
group.
security services ip_group delete <row id> Delete a LAN or WAN IP group.
security services ip_group delete_ip <row id> Remove an IP address from a LAN or
WAN IP group.
security services ip_group edit <row id> Configure an existing LAN or WAN IP
group.
security services qos_profile add Add a QoS profile.
security services qos_profile delete <row id> Delete a QoS profile.
security services qos_profile edit <row id> Configure an existing QoS profile.
upnp security upnp configure Configure UPnP.
Table 9. System mode configuration commands
Submode Command Name Purpose
logging
system logging configure Configure routing logs for accepted and
dropped IPv4 and IPv6 packets.
system logging remote configure Configure email logs and alerts, schedule
email logs and alerts, and configure a syslog
server.
Table 8. Security mode configuration commands (continued)
Submode Command Name Purpose