NETGEAR ProSAFE SRX5308 - Use the IPSec VPN Wizard for Client and Gateway Configurations

System Mode Configuration Commands
203
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
SRX5308> system logging configure
system-config[logging-ipv4-ipv6]> lan_wan_drop_packet_logs Y
system-config[logging-ipv4-ipv6]> wan_lan_drop_packet_logs Y
system-config[logging-ipv4-ipv6]> change_of_time_by_NTP_logs Y
system-config[logging-ipv4-ipv6]> secure_login_attempts_logs Y
system-config[logging-ipv4-ipv6]> reboot_logs Y
system-config[logging-ipv4-ipv6]> unicast_traffic_logs Y
system-config[logging-ipv4-ipv6]> bandwidth_limit_logs Y
system-config[logging-ipv4-ipv6]> save
Related show command: show system logging setup and show system logs
system logging remote configure
This command configures email logs and alerts, schedules email logs and alerts, and
configures a syslog server. After you have issued the system logging remote
configure command, you enter the system-config [logging-remote] mode, and then you
can configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
Other event logs
source_mac_filter_logs Y or N Enables or disables logging of packets
from MAC addresses that match the
source MAC address filter settings.
session_limit_logs Y or N Enables or disables logging of packets
that are dropped because the session
limit has been exceeded.
bandwidth_limit_logs Y or N Enables or disables logging of packets
that are dropped because the
bandwidth limit has been exceeded.
Step 1 Format system logging remote configure
Mode system
Step 2 Format log_identifier <identifier>
Keyword Associated
Keyword to Select
Description