NETGEAR ProSAFE SRX5308 - Security Settings (Security Mode) Show Commands

Overview of the Show Commands
269
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Security Settings (Security Mode) Show Commands
Enter the show security ? command at the CLI prompt to display the submodes in the
show security mode. The following table lists the submodes and their commands in
alphabetical order:
wan (continued)
show net wan wan ipv6 setup <wan
interface>
Display the IPv6 configuration for a WAN
interface.
show net wan wan ipv6 status
<wan interface>
Display the IPv6 connection status for a WAN
interface.
wan_settings show net wan_settings wanmode Display the IPv4 WAN routing mode.
Table 13. Show commands: show security mode
Submode Command Name Purpose
address_filter
show security address_filter
enable_email_log
Display the configuration of the IP/MAC
binding log.
show security address_filter
ip_or_mac_binding setup
Display the IPv4 and IPv6 MAC bindings.
show security address_filter mac_filter setup Display the MAC addresses for source
MAC filtering.
bandwidth show security bandwidth profile setup Display the configured bandwidth profiles.
content_filter
show security content_filter block_group Display the groups for which content
filtering is enabled.
show security content_filter
blocked_keywords
Display the keywords that are blocked.
show security content_filter content_filtering Display the status of content filtering and
the web components.
show security content_filter trusted_domains Display the trusted domains.
firewall
show security firewall advanced algs Display whether or not SIP ALG is enabled.
show security firewall attack_checks igmp Display whether or not the IGMP proxy is
enabled.
show security firewall attack_checks setup
ipv4
Display which WAN and LAN security
checks are enabled for IPv4.
show security firewall attack_checks setup
ipv6
Display which WAN and LAN security
checks are enabled for IPv6.
show security firewall attack_checks
vpn_passthrough setup
Display which VPN pass-through features
are enabled.
Table 12. Show commands: show net mode (continued)
Submode Command Name Purpose