EasyManua.ls Logo

NETGEAR ProSAFE SRX5308 - WAN Traffic Meter Show Command

NETGEAR ProSAFE SRX5308
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Show Commands
306
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
IPv6 Connection Type: Dynamic IP (DHCPv6)
IPv4 Connection State: Not Yet Connected
IPv6 Connection State: Not Yet Connected
Link State: LINK DOWN
Upload Connection Speed: 1000000
Download Connection Speed: 1000000
Gateway: 0.0.0.0
Primary DNS: 0.0.0.0
Secondary DNS: 0.0.0.0
Gateway (IPv6):
Primary DNS(IPv6):
Secondary DNS(IPv6):
WAN Traffic Meter Show Command
show system traffic_meter setup <wan interface>
This command displays the configuration of the traffic meter and the Internet traffic statistics.
For the WAN interface, type WAN1, WAN2, WAN3, or WAN4.
Enable Traffic Meter
____________________
Traffic Meter is Enabled
Limit Type Both Directions
Monthly Limit in (MB): 255000
Increase this month limit: Enabled
Increase limit by in (MB): 125000
This month limit:
Traffic Counter
________________
Traffic Counter: Specific Time
Restart Time (HH:MM-Day of Month): 12:0 AM - 1
Send e-mail before restarting: Enabled
When Limit is reached
______________________

Table of Contents

Other manuals for NETGEAR ProSAFE SRX5308

Related product manuals