NETGEAR ProSAFE SRX5308 - Chapter 5 System Mode Configuration Commands; Remote Management Commands

186
5
5. System Mode Configuration Commands
This chapter explains the configuration commands, keywords, and associated parameters in the
system mode. The chapter includes the following sections:
• Remote Management Commands
• SNMP Commands
• Time Zone Command
• WAN Traffic Meter Command
• Firewall Logs and Email Alerts Commands
IMPORTANT:
After you have issued a command that includes the word
configure, add, or edit, you need to save (or cancel) your
changes. For more information, see Save Commands on page 12.
Remote Management Commands
system remote_management https configure
This command configures remote management over HTTPS. After you have issued the
system remote_management https configure command, you enter the
system-config [https] mode, and then you can configure one keyword and associated
parameter or associated keyword at a time in the order that you prefer.
Note: You can configure remote management over HTTPS for both IPv4
and IPv6 connections because these connections are not mutually
exclusive.
Step 1 Format system remote_management https configure
Mode system