Introduction
9
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Common Parameters
Parameter values might be names (strings) or numbers. To use spaces as part of a name
parameter, enclose the name value in double quotes. For example, the expression “System
Name with Spaces” forces the system to accept the spaces. Empty strings (“”) are not valid
user-defined strings. The following table describes common parameter values and value
formatting:
The Four Categories of Commands
There are four CLI command categories:
• Configuration commands with four main configuration modes. For more information, see
the following section, The Four Main Modes for Configuration Commands). Save
commands also fall into this category (see Save Commands on page 12).
• Show commands that are available for the four main configuration modes (see Chapter 7,
Overview of the Show Commands and Chapter 8, Show Commands).
• Utility commands (see Chapter 9, Utility Commands).
• Global commands (see Global Commands on page 13).
Table 2. Common parameters
Parameter Description
ipaddr This parameter is a valid IPv4 address. You need to enter the IP address in the a.b.c.d
format, in which each octet is a number in the range from 0 to 255 (both inclusive), for
example, 10.12.140.218.
The CLI accepts decimal, hexadecimal, and octal formats through the following input
formats (where n is any valid decimal, hexadecimal, or octal number):
• 0xn (CLI assumes hexadecimal format)
• 0n (CLI assumes octal format with leading zeros)
• n (CLI assumes decimal format)
ipv6-address This parameter is a valid IPv6 address. You can enter the IPv6 address in the following
formats:
• FE80:0000:0000:0000:020F:24FF:FEBF:DBCB, or
• FE80:0:0:0:20F:24FF:FEBF:DBCB, or
• FE80::20F:24FF:FEBF:DBCB, or
• FE80:0:0:0:20F:24FF:128:141:49:32
For additional information, see RFC 3513.
Character strings Use double quotation marks to identify character strings, for example, “System Name with
Spaces”. An empty string (“”) is not valid.
To Next Page
Loading...
