NETGEAR ProSAFE SRX5308 - Chapter 8 Show Commands; Network Settings (Net Mode) Show Commands; WAN Ipv4 and WAN Ipv6 Show Commands

273
8
8. Show Commands
This chapter explains the show commands and associated parameters for the four configuration
command modes. The chapter includes the following sections:
• Network Settings (Net Mode) Show Commands
• Security Settings (Security Mode) Show Commands
• Administrative and Monitoring Settings (System Mode) Show Commands
• VPN Settings (VPN Mode) Show Commands
Network Settings (Net Mode) Show Commands
This section contains the following subsections:
• WAN IPv4 and WAN IPv6 Show Commands
• IPv6 Mode, IPv6 Tunnel, and SIIT Show Commands
• LAN DHCP Show Commands
• Dynamic DNS Show Commands
• IPv4 LAN Show Commands
• IPv6 LAN Show Commands
• DMZ Show Commands
• Routing Show Commands
• Network Statistics Show Commands
WAN IPv4 and WAN IPv6 Show Commands
show net wan_settings wanmode
This command displays the IPv4 WAN routing mode:
Routing Mode between WAN and LAN
__________________________________
NAT is Enabled
This chapter explains the show commands and associated parameters for the four configuration
command modes. The chapter includes the following sections:
• Network Settings (Net Mode) Show Commands
• Security Settings (Security Mode) Show Commands
• Administrative and Monitoring Settings (System Mode) Show Commands
• VPN Settings (VPN Mode) Show Commands
Network Settings (Net Mode) Show Commands
This section contains the following subsections:
• WAN IPv4 and WAN IPv6 Show Commands
• IPv6 Mode, IPv6 Tunnel, and SIIT Show Commands
• LAN DHCP Show Commands
• Dynamic DNS Show Commands
• IPv4 LAN Show Commands
• IPv6 LAN Show Commands
• DMZ Show Commands
• Routing Show Commands
• Network Statistics Show Commands
WAN IPv4 and WAN IPv6 Show Commands
show net wan_settings wanmode
This command displays the IPv4 WAN routing mode:
Routing Mode between WAN and LAN
__________________________________
NAT is Enabled