Overview of the Show Commands
270
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Administrative and Monitoring Settings (System Mode)
Show Commands
Enter the show system ? command at the CLI prompt to display the submodes in the show
system mode. The following table lists the submodes and their commands in alphabetical
order:
firewall
(continued)
show security firewall ipv4 setup dmz_wan Display the IPv4 DMZ WAN firewall rules.
show security firewall ipv4 setup lan_dmz Display the IPv4 LAN DMZ firewall rules.
show security firewall ipv4 setup lan_wan Display the IPv4 LAN WAN firewall rules.
show security firewall ipv6 setup Display all IPv6 firewall rules.
show security firewall session_limit Display the session limit settings.
show security firewall session_settings Display the session time-out settings.
porttriggering_rules
show security porttriggering_rules setup Display the port triggering rules.
show security porttriggering_rules status Display the port triggering status.
schedules show security schedules setup Display the configured schedules.
services show security services setup Display the configured custom services.
show security services qos_profile setup Display the configured QoS profiles.
show security services ip_group ip_setup Display the configured IP groups.
upnp
show security upnp portmap Display the UPnP portmap table.
show security upnp setup Display the UPnP configuration.
Table 14. Show commands: show system mode
Submode Command Name Purpose
not applicable
show sysinfo Display system information, including MAC
addresses, serial number, and firmware
version.
show system firmware_version Display the firmware version.
logging
show system logging remote setup Display the configuration and the schedule of
the email logs.
show system logging setup Display the configuration of the IPv4 and
IPv6 logs.
logs show system logs Display the system logs.
Table 13. Show commands: show security mode (continued)
Submode Command Name Purpose
To Next Page
Loading...
