NETGEAR ProSAFE SRX5308 - Ipv6 LAN Commands

Net Mode Configuration Commands
66
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net lan ipv4 traffic_meter delete <row id>
This command deletes a LAN traffic meter profile by specifying its row ID.
Related show command: show net lan ipv4 traffic_meter setup
IPv6 LAN Commands
net lan ipv6 configure
This command configures the IPv6 LAN address settings and DHCPv6. After you have
issued the net lan ipv6 configure command, you enter the net-config [lan-ipv6] mode,
and then you can configure one keyword and associated parameter or associated keyword at
a time in the order that you prefer.
Format net lan ipv4 traffic_meter delete <row id>
Mode net
Step 1 Format net lan ipv6 configure
Mode net
Step 2 Format static address <ipv6-address>
static prefix_length <prefix length>
dhcp server_enable {N | Y {dhcp mode {Stateless | Stateful}}}
prefix_delegation_enable {Y | N}
dhcp domain name <domain name>
dhcp server_preference <number>
dhcp dns_type {useDnsProxy | useDnsFromISP | useEnteredDns
{dhcp primary_dns <ipv6-address>} [dhcp secondary_dns
<ipv6-address>]}
dhcp rebind_time <seconds>
Mode net-config [lan-ipv6]
Keyword (consists of two
separate words)
Associated Keyword to
Select or Parameter to Type
Description
static address ipv6-address The link-local IPv6 address.
static prefix_length prefix length The IPv6 prefix length (integer) of the
link-local IPv6 address.
dhcp server_enable Y or N Enables or disables DHCPv6. If you enable
DHCPv6, you also need to issue the dhcp
mode keywords to specify a stateless or
stateful DCHPv6 server, and configure the
server.