NETGEAR ProSAFE SRX5308 - Ipsec VPN Mode Config Commands

VPN Mode Configuration Commands
228
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
vpn ipsec vpnpolicy drop <vpn policy name>
This command terminates an active VPN connection by specifying the name of the VPN
policy.
Related show command: show vpn ipsec vpnpolicy setup and show vpn ipsec vpnpolicy status
IPSec VPN Mode Config Commands
vpn ipsec mode_config configure <record name>
This command configures a Mode Config record. After you have issued the vpn ipsec
mode_config configure command to specify a record name, you enter the
vpn-config [modeConfig] mode, and then you can configure one keyword and associated
parameter or associated keyword or associated keyword at a time in the order that you
prefer.
Format vpn ipsec vpnpolicy drop <vpn policy name>
Mode vpn
Step 1 Format vpn ipsec mode_config configure <record name>
Mode vpn
Step 2 Format first_pool_start_ip <ipaddress>
first_pool_end_ip <ipaddress>
second_pool_start_ip <ipaddress>
second_pool_end_ip <ipaddress>
third_pool_start_ip <ipaddress>
third_pool_end_ip <ipaddress>
wins_server_primary_ip <ipaddress>
wins_server_secondary_ip <ipaddress>
dns_server_primary_ip <ipaddress>
dns_server_secondary_ip <ipaddress>