NETGEAR ProSAFE SRX5308 - Create an IPv6 Gateway-to-Gateway VPN Tunnel with the Wizard

VPN Mode Configuration Commands
208
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
IPSec VPN Wizard Command
vpn ipsec wizard configure <Gateway | VPN_Client>
This command configures the IPSec VPN wizard for a gateway-to-gateway or
gateway-to-VPN client connection. After you have issued the vpn ipsec wizard
configure command to specify the type of peer for which you want to configure the wizard,
you enter the vpn-config [wizard] mode, and then you can configure one keyword and
associated parameter or associated keyword or associated keyword at a time in the order
that you prefer.
Step 1 Format vpn ipsec wizard configure {Gateway | VPN_Client}
Mode vpn
Step 2 Format ip_version {IPv4 | IPv6}
conn_name <name>
preshared_key <key>
local_wan_interface {WAN1 | WAN2 | WAN3 | WAN4}
enable_rollover {N | Y {rollover_gateway {WAN1 | WAN2 | WAN3 |
WAN4})
remote_wan_ipaddress {<ipaddress> | <ipv6-address> |
<domain name>}
local_wan_ipaddress {<ipaddress> | <ipv6-address> |
<domain name>}
remote_lan_ipaddress <ipaddress>
remote_lan_net_mask <subnet mask>
remote_lan_ipv6address <ipv6-address>
remote_lan_prefixLength <prefix length>
Mode vpn-config [wizard]
Keyword Associated Keyword to
Select or Parameter to Type
Description
ip_version IPv4 or IPv6 Specifies the IP address version for both the
local and remote endpoints:
• IPv4. Both endpoints use IPv4 addresses.
For the remote LAN IP address, you need to
issue the remote_lan_ipaddress and
remote_lan_netMask keywords and
specify the associated parameters.
• IPv6. Both endpoints use IPv6 addresses.
For the remote LAN IP address, you need to
issue the remote_lan_ipv6address and
remote_lan_prefixLength keywords
and specify the associated parameters.