NETGEAR ProSAFE SRX5308 - Ipv6 WAN Commands

Net Mode Configuration Commands
46
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net protocol_binding enable
This command enables a protocol binding by specifying its row ID.
Related show command: show net protocol_binding setup
IPv6 WAN Commands
net ipv6 ipmode configure
This command configures the IPv6 mode. After you have issued the net ipv6 ipmode
configure command, you enter the net-config [mode] mode, and then you can configure
the IP mode. You can select support for IPv4 only or for both IPv4 and IPv6.
WARNING!
Changing the IP mode causes the VPN firewall to reboot.
Command example:
FVS318N> net ipv6 ipmode configure
net-config[mode]> ip_type IPv4/IPv6
net-config[mode]> save
Related show command: show net ipv6 ipmode setup
Format net protocol binding enable <row id>
Mode security
Step 1 Format net ipv6 ipmode configure
Mode net
Step 2 Format ip_type {IPv4_Only | IPv4/IPv6}
Mode net-config [mode]
Keyword Associated Keyword to
Select
Description
ip_type IPv4_Only or IPv4/IPv6 Specifies the IPv6 routing mode.