NETGEAR ProSAFE SRX5308 - System Remote_Management Telnet Configure

System Mode Configuration Commands
188
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
SRX5308> system remote_management https configure
system-config[https]> ip_version IPv4
system-config[https]> enable_ipv4 Y
system-config[https]> access_type Everyone
system-config[https]> port 445
system-config[https]> save
Related show command: show system remote_management setup
system remote_management telnet configure
This command configures remote management over Telnet. After you have issued the
system remote_management telnet configure command, you enter the
system-config [telnet] mode, and then you can configure one keyword and associated
parameter or associated keyword at a time in the order that you prefer.
Note: You can configure remote management over Telnet for both IPv4
and IPv6 connections because these connections are not mutually
exclusive.
access_type6 Everyone, IP_Range, or
To_this_PC_only
Specifies the type of access:
• Everyone. Enables access to all IP addresses.
You do not need to configure any IP address.
• IP_Range. Enables access to a range of IP
addresses. You also need to configure the
from_address6 and end_address6 keywords
and associated parameters.
• To_this_PC_only. Enables access to a single IP
address. You also need to configure the
only_this_pc_ipv6 keyword and associated
parameter.
from_address6 ipv6-address The start IP address if you have set the
access_type6 keyword to IP_Range.
end_address6 ipv6-address The end IP address if you have set the
access_type6 keyword to IP_Range.
only_this_pc_ipv6 ipaddress The single IP address if you have set the
access_type6 keyword to To_this_PC_only.
port number The number of the port through which access is
allowed.
Keyword Associated Keyword to
Select or Parameter to Type
Description