NETGEAR ProSAFE SRX5308 - SSL VPN Client and Client Route Commands

VPN Mode Configuration Commands
248
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
SRX5308> vpn sslvpn portforwarding hostconfig add
vpn-config[portforwarding-host-settings]> server_ip 192.168.51.227
vpn-config[portforwarding-host-settings]> domain_name RemoteDesktop
vpn-config[portforwarding-host-settings]> save
Related show command: show vpn sslvpn portforwarding hostconfig
vpn sslvpn portforwarding hostconfig delete <row id>
This command deletes a host name for an SSL port forwarding application by specifying the
row ID of the host name.
Related show command: show vpn sslvpn portforwarding hostconfig
SSL VPN Client and Client Route Commands
vpn sslvpn client ipv4
This command configures the SSL client IP address range. After you have issued the vpn
sslvpn client ipv4 command, you enter the vpn-config [sslvpn-client-ipv4-settings]
mode, and then you can configure one keyword and associated parameter or associated
keyword at a time in the order that you prefer.
Keyword Associated
Parameter to Type
Description
server_ip ipaddress The IP address of the local server that hosts the application.
Note: The IP address needs to be the same as the IP address
that you assigned through the vpn sslvpn portforwarding
appconfig add command for the same application.
domain_name domain name The domain name for the local server that hosts the application.
Format vpn sslvpn portforwarding hostconfig delete <row id>
Mode vpn
Step 1 Format vpn sslvpn client ipv4
Mode vpn