NETGEAR ProSAFE SRX5308 - Ipv4 LAN Commands

Net Mode Configuration Commands
54
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
SRX5308> net ddns configure
net-config[ddns]> wan2 enable DynDNS
net-config[ddns]> wan2 hostname adminnetgear.dyndns.org
net-config[ddns]> wan2 username jaybrown
net-config[ddns]> wan2 password 4hg!RA278s
net-config[ddns]> wan2 wild_flag_enable N
net-config[ddns]> wan2 time_update_enable Y
net-config[ddns]> save
Related show command: show net ddns setup
IPv4 LAN Commands
net lan ipv4 configure <vlan id>
This command configures a new or existing VLAN, that is, a VLAN ID and a VLAN profile.
After you have issued the net lan ipv4 configure command to specify a new or
existing VLAN ID, you enter the net-config [lan-ipv4] mode, and then you can configure one
keyword and associated parameter or associated keyword at a time in the order that you
prefer.
{wan1 | wan2 | wan3 | wan4}
username
user name Configures a user name (string) for a
DDNS server.
{wan1 | wan2 | wan3 | wan4}
password
password Configures a password (string) for a
DDNS server.
{wan1 | wan2 | wan3 | wan4}
wild_flag_enable
Y or N Enables or disables the use of wildcards
for DDNS.
{wan1 | wan2 | wan3 | wan4}
time_update_enable
Y or N Enables or disables the automatic update
of the DDNS service after 30 days.
Step 1 Format net lan ipv4 configure <vlan id>
Mode net
Keyword (might consist of two
separate words)
Associated Keyword to
Select or Parameter to Type
Description