NETGEAR ProSAFE SRX5308 - Use a DHCPv6 Server to Configure an IPv6 Internet Connection

Net Mode Configuration Commands
55
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Step 2 Format profile_name <name>
port_membership {[port 1 {Y | N}] | [port 2 {Y | N}] |
[port 3 {Y | N}] | [port 4 {Y | N}]}
static address <ipaddress>
static subnet_mask <subnet mask>
dhcp mode {None | DHCP-Server | DHCP-Relay}
proxy dns_enable {Y | N}
dhcp domain_name <domain name>
dhcp start_address <ipaddress>
dhcp end_address <ipaddress>
dhcp primary_dns <ipaddress>
dhcp secondary_dns <ipaddress>
dhcp wins_server <ipaddress>
dhcp lease_time <hours>
enable_ldap {Y | N}
ldap_serverip <ipaddress>
ldap_search_base <search base>
ldap_port <number>
dhcp relay_gateway <ipaddr
ess>
inter_vlan_routing {Y | N}
Mode net-config [lan-ipv4]
Keyword (might consist of
two separate words)
Associated Keyword to
Select or Parameter to Type
Description
profile_name name The name of the VLAN profile.
port_membership port1
Y or N
Specifies whether or not the port is a member of
the VLAN. You need to specify each port
individually.
port_membership port2
port_membership port3
port_membership port4
static address ipaddress The static IPv4 address for the VLAN.
static subnet_mask subnet mask The IPv4 subnet mask for the VLAN profile.