NETGEAR ProSAFE SRX5308 - Set Up IP;MAC Bindings

System Mode Configuration Commands
192
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Time Zone Command
system time configure
This command configures the system time, date, and NTP servers. After you have issued the
system time configure command, you enter the system-config [time] mode, and then
you can configure one keyword and associated parameter or associated keyword at a time in
the order that you prefer.
Step 1 Format system time configure
Mode system
Step 2 Format timezone <timezone>
auto_daylight {Y | N}
resolv_ipv6_ddress {Y | N}
ntp_mode {Authoritative_Mode {stratum <number>} |
Sync_to_NTP_Servers_on_Internet | Sync_to_NTP_Servers_on_VPN}
{vpn_policy <vpn policy name>}}
set_date_time_manually {N | Y {ntp_hour <hour> | ntp_minutes
<minutes> | ntp_seconds <seconds> | ntp_day <day> | ntp_month
<month> | ntp_year <year>}}
use_default_servers {Y | N}
configure_ntp_servers {Y | N {ntp_server1 {<ipaddress> |
<domain name>}} {ntp_server2 {<ipaddress> | <domain name>}}}
Mode system-config [time]
Keyword Associated Keyword to
Select or Parameter to Type
Description
timezone timezone keyword For a list of time zones that you can enter,
see Table 11.
auto_daylight Y or N Enables or disables automatic adjustment for
daylight savings time.
resolv_ipv6_ddress Y or N Specifies whether or not the VPN firewall
automatically resolves a domain name for an
NTP server to an IPv6 address:
• Y. A domain name is resolved to an IPv6
address.
• N. A domain name is resolved to an IPv4
address.