NETGEAR ProSAFE SRX5308 - Chapter 3 Net Mode Configuration Commands; General WAN Commands

27
3
3. Net Mode Configuration Commands
This chapter explains the configuration commands, keywords, and associated parameters in the
net mode. The chapter includes the following sections:
• General WAN Commands
• IPv4 WAN Commands
• IPv6 WAN Commands
• IPv6 Tunnel Commands
• Dynamic DNS Commands
• IPv4 LAN Commands
• IPv6 LAN Commands
• IPv4 DMZ Setup Commands
• IPv6 DMZ Setup Commands
• WAN QoS Commands
• IPv4 Routing Commands
• IPv6 Routing Commands
IMPORTANT:
After you have issued a command that includes the word
configure, add, or edit, you need to save (or cancel) your
changes. For more information, see Save Commands on page 12.
General WAN Commands
net wan port_setup configure <wan interface>
This command configures the advanced WAN settings for a WAN interface, that is, the MTU,
port speed, MAC address, failure detection method, and upload and download settings of the
VPN firewall. After you have issued the net wan port_setup configure command to
specify one of the four WAN interfaces (that is, WAN1, WAN2, WAN3, or WAN4), you enter
the net-config [port_setup] mode, and then you can configure the advanced settings for the
specified interface in the order that you prefer.