NETGEAR ProSAFE SRX5308 - RADIUS Server Command; Vpn Ipsec Radius Configure

VPN Mode Configuration Commands
263
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
vpn-config[sslvpn-policy-settings]> end_port 35408
vpn-config[sslvpn-policy-settings]> policy_permission Permit
vpn-config[sslvpn-policy-settings]> save
Related show command: show vpn sslvpn policy
vpn sslvpn policy delete <row id>
This command deletes an SSL VPN policy by specifying its row ID.
Related show command: show vpn sslvpn policy
RADIUS Server Command
vpn ipsec radius configure
This command configures a RADIUS server. After you have issued the vpn ipsec radius
configure command, you enter the vpn-config [radius-config] mode, and then you can
configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
Format vpn sslvpn policy delete <row id>
Mode vpn
Step 1 Format vpn ipsec radius configure
Mode vpn
Step 2 Format enable {Y | N}
radius-server <ipaddress>
secret <secret>
nas_identifier <identifier>
backup_server_enable {Y | N}
backup-radius_server <ipaddress>
backup_server_secret <secret>
backup_server_nas_identifier <identifier>
timeout <seconds>
retries <number>
Mode vpn-config [radius-config]