NETGEAR ProSAFE SRX5308 - Port Triggering Commands; Security Porttriggering_Rules Add

Security Mode Configuration Commands
173
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
FVS318N> security address_filter ip_or_mac_binding enable_email_log IPv4
security-config[ip-or-mac-binding]> enable_email_logs Y
security-config[ip-or-mac-binding]> save
Related show command: show security address_filter enable_email_log
Port Triggering Commands
security porttriggering_rules add
This command configures a new port triggering rule. After you have issued the security
porttriggering_rules add command, you enter the
security-config [porttriggering-rules] mode, and then you can configure one keyword and
associated parameter or associated keyword at a time in the order that you prefer.
Keyword Associated Keyword
to Select
Description
enable_email_logs Y or N Enables or disables the email log or IP/MAC Binding vio-
lations.
Step 1 Format security porttriggering_rules add
Mode security
Step 2 Format name <rule name>
enable_rule {Y | N}
protocol {TCP | UDP}
outgoing_start_port <number>
outgoing_end_port <number>
incoming_start_port <number>
incoming_end_port <number>
Mode security-config [porttriggering-rules]
Keyword Associated Keyword to
Select or Parameter to Type
Description
name rule name The name (alphanumeric string) of the port
triggering rule.
enable_rule Y or N Enables or disables the port triggering rule.
protocol TCP or UDP Specifies whether the port uses the TCP or UDP
protocol.