NETGEAR ProSAFE SRX5308 - Page 199

System Mode Configuration Commands
199
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
increase_limit_enable Y or N Enables or disables automatic
increase of the limit after the meter
has exceeded the configured limit. If
you enable an automatic increase,
issue the increase_limit_by
keyword to specify the number of MB.
increase_limit_by number The number in MB to increase the
configured limit of the traffic meter.
Traffic counter configuration
counter SpecificTime or RestartCounter Specifies how the traffic counter is
restarted:
• SpecificTime. Restarts the traffic
counter on a specific day and time.
You need to set the
day_of_month, time_hour,
time_meridian, and
time_minute keywords and
associated parameters.
• RestartCounter. Restarts the traffic
counter after you have saved the
command.
day_of_month day The day in the format DD (01 to 31)
that the traffic counter restarts. This
keyword applies only if you have set
the counter keyword to
SpecificTime.
time_hour hour The hour in the format HH (00 to 12)
that the traffic counter restarts. This
keyword applies only if you have set
the counter keyword to
SpecificTime.
time_meridian AM or PM Specifies the meridiem for the hour
that the traffic counter restarts. This
keyword applies only if you have set
the counter keyword to
SpecificTime.
time_minute minutes The minutes in the format MM (00 to
59) that the traffic counter restarts.
This keyword applies only if you have
set the counter keyword to
SpecificTime.
send_email_report Y or N Specifies whether or not an email
report is sent when the traffic counter
restarts.
Keyword Associated Keyword to Select or
Parameter to Type
Description