NETGEAR ProSAFE SRX5308 - Page 200

System Mode Configuration Commands
200
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
SRX5308> system traffic_meter configure WAN1
system-config[traffic-meter]> enable Y
system-config[traffic-meter]> limit_type Downloadonly
system-config[traffic-meter]> monthly_limit 150000
system-config[traffic-meter]> increase_limit_enable Y
system-config[traffic-meter]> increase_limit_by 50000
system-config[traffic-meter]> counter SpecificTime
system-config[traffic-meter]> day_of_month 01
system-config[traffic-meter]> time_hour 00
system-config[traffic-meter]> time_meridian AM
system-config[traffic-meter]> time_minute 00
system-config[traffic-meter]> send_email_report Y
system-config[traffic-meter]> block_type Block-all-traffic-except-email
system-config[traffic-meter]> send_email_alert Y
system-config[traffic-meter]> save
Related show command: show system traffic_meter setup <wan interface>
Action when limit is reached
block_type Block-all-traffic, or
Block-all-traffic-except-email
Specifies the type of traffic blocking
after the meter has exceeded the
configured limit.
send_email_alert Y or N Specifies whether or not an email alert
is sent when the traffic limit is
reached.
Keyword Associated Keyword to Select or
Parameter to Type
Description