NETGEAR ProSAFE SRX5308 - Configure Port Triggering

System Mode Configuration Commands
197
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
SRX5308> system time configure
system-config[time]> timezone GMT-08:00::Pacific_Time-US
system-config[time]> auto_daylight Y
system-config[time]> resolve_ipv6_address N
system-config[time]> ntp_mode Sync_to_NTP_Servers_on_Internet
system-config[time]> use_default_servers Y
system-config[time]> configure_ntp_servers N
system-config[time]> save
Related show command: show system time setup
GMT+11:30::Norfolk_I
GMT+12:00::Auckland
GMT+12:00::Wellington
GMT+12:00::New_Zealand
GMT+12:00::Fiji
GMT+13:00::Tonga
GMT+14:00::Kiribati
Table 11. Timezone keywords (continued)
GMT time and location
Note: Enter the keywords exactly as stated (you can use autocompletion keys). If
there are two locations for the same time zone, enter the location exactly as stated.
For example, either enter GMT-11:00::Samoa or enter GMT-10:00::Hawaii.