NETGEAR ProSAFE SRX5308 - Page 109

Security Mode Configuration Commands
109
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Related show command: show security services ip_group ip_setup
security services ip_group add_ip_to <group name>
This command adds an IPv4 address to a LAN or WAN IP group. After you have issued the
security services ip_group add_ip_to command to specify the LAN IP or WAN IP
group name to which an IP address is to be added, you enter the security-config [ipGroup-Ip]
mode, and then you can add the IP address.
Command example:
SRX5308> security services ip_group add_ip_to TechSupport
security-config[ipGroup-Ip]> ip_address 10.55.3.201
security-config[ipGroup-Ip]> save
Related show command: show security services ip_group ip_setup
Keyword (might consist of two
separate words)
Associated Keyword to
Select or Parameter to Type
Description
ip_group_type LAN-Group or WAN-Group Specifies the type of IP group:
• LAN-Group. The group can be used as
a firewall object in an IPv4 LAN firewall
rule.
• WAN-Group. The group can be used as
a firewall object in an IPv4 WAN firewall
rule.
ip_group_name group name The name (alphanumeric string) of the
group.
Step 1 Format security services ip_group add_ip_to <group name>
Mode security
Step 2 Format ip_address <ipaddress>
Mode security-config [ipGroup-Ip]
Keyword Associated
Parameter to Type
Description
ip_address ipaddress The IPv4 address that needs to be assigned to the IP group.