NETGEAR ProSAFE SRX5308 - Page 119

Security Mode Configuration Commands
119
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example: See the command example for the security firewall ipv4 add_rule lan_wan
outbound command.
Related show command: show security firewall ipv4 setup lan_wan
log NEVER or ALWAYS Specifies whether logging is
disabled or enabled.
bandwidth_profile profile name The name of the bandwidth profile
that you have specified with the
security bandwidth profile add
command.
nat_ip type Auto, WAN1, WAN2, WAN3, or
WAN4
Specifies the type of NAT IP
address for a nonblocking rule:
• Auto. The source address of the
outgoing packets is autodetected
through the configured routing
and load balancing rules.
• WAN1, WAN2, WAN3, or WAN4.
The IP address of the selected
WAN interface.
Note: The nat_ip type and
nat_ip address keywords are
mutually exclusive.
nat_ip address ipaddress The NAT IP address, if the address
is different from the IP address of a
WAN interface, for example, a
secondary WAN IP address.
Note: The nat_ip type and
nat_ip address keywords are
mutually exclusive.
Keyword (might consist of two
separate words)
Associated Keyword to Select or
Parameter to Type
Description