NETGEAR ProSAFE SRX5308 - Page 131

Security Mode Configuration Commands
131
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
wan_users address_wise ANY, SINGLE_ADDRESS, or
ADDRESS_RANGE
Specifies the type of WAN address.
The address_wise and
group_wise keywords are
mutually exclusive.
wan_user_start_ip ipaddress There are two options:
• The IP address if the wan_user
keyword is set to
SINGLE_ADDRESS.
• The start IP address if the
wan_user keyword is set to
ADDRESS_RANGE.
wan_user_end_ip ipaddress The end IP address if the
wan_user keyword is set to
ADDRESS_RANGE.
wan_users group_wise group name The name of the WAN IP group.
The WAN IP group name is a name
that you have specified with the
security services ip_group add
command.
The address_wise and
group_wise keywords are
mutually exclusive.
QoS profile, logging, and NAT IP address
qos_profile profile name The name of the QoS profile that
you have specified with the security
services qos_profile add command.
log NEVER or ALWAYS Specifies whether logging is
disabled or enabled.
nat_ip type Auto, WAN1, WAN2, WAN3, or
WAN4
Specifies the type of NAT IP
address for a nonblocking rule:
• Auto. The source address of the
outgoing packets is autodetected
through the configured routing
and load balancing rules.
• WAN1, WAN2, WAN3, or WAN4.
The IP address of the selected
WAN interface.
Note: The nat_ip type and
nat_ip address keywords are
mutually exclusive.
Keyword (might consist of two
separate words)
Associated Keyword to Select or
Parameter to Type
Description