NETGEAR ProSAFE SRX5308 - Page 139

Security Mode Configuration Commands
139
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
security-config[firewall-ipv4-dmz-wan-inbound]> translate_to_port_number port 6700
security-config[firewall-ipv4-dmz-wan-inbound]> wan_destination_ip_address_start 10.168.50.1
security-config[firewall-ipv4-dmz-wan-inbound]> wan_users Single_Address
security-config[firewall-ipv4-dmz-wan-inbound]> wan_user_start_ip 10.132.215.4
security-config[firewall-ipv4-dmz-wan-inbound]> log Always
security-config[firewall-ipv4-dmz-wan-inbound]> save
Related show command: show security firewall ipv4 setup dmz_wan
security firewall ipv4 edit_rule dmz_wan inbound <row id>
This command configures an existing IPv4 DMZ WAN inbound firewall rule. After you have
issued the security firewall ipv4 edit_rule dmz_wan inbound command to
specify the row to be edited (for row information, see the output of the
show security firewall
ipv4 setup dmz_wan
command), you enter the security-config [firewall-ipv4-dmz-wan-inbound]
mode. You can then edit one keyword and associated parameter or associated keyword at a
time in the order that you prefer. However, note that the setting of the action keyword
determines which other keywords and parameters you can apply to a rule.
Step 1 Format security firewall ipv4 edit_rule dmz_wan inbound <row id>
Mode security
Step 2 Format service_name {default_services <default service name> |
{custom_services <custom service name>}
action {ALWAYS_BLOCK | ALWAYS_ALLOW |
BLOCK_BY_SCHEDULE_ELSE_ALLOW {schedule {Schedule1 |
Schedule2 | Schedule3}} | ALLOW_BY_SCHEDULE_ELSE_BLOCK
{schedule {Schedule1 | Schedule2 | Schedule3}}}
send_to_dmz_server_ip <ipaddress>
translate_to_port_number enable {N | Y
{translate_to_port_number port <number>}}
{wan_destination_ip_address {WAN1 | WAN2 | WAN3 | WAN4}
wan_destination_ip_address_start <ipaddress>}
dmz_users {ANY | SINGLE_ADDRESS {dmz_user_start_ip <ipaddress>}
| ADDRESS_RANGE {dmz_user_start_ip <ipaddress>}
{dmz_user_end_ip <ipaddress>}}
wan_users {address_wise {ANY | SIN
GLE_ADDRESS {wan_user_start_ip
<ipaddress>} | ADDRESS_RANGE {wan_user_start_ip <ipaddress>}
{wan_user_end_ip <ipaddress>}} | group_wise <group name>}
log {NEVER | ALWAYS}
Mode security-config [firewall-ipv4-dmz-wan-inbound]