NETGEAR ProSAFE SRX5308 - Configure LAN WAN Rules

Security Mode Configuration Commands
145
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
SRX5308> security firewall ipv4 add_rule lan_dmz outbound
security-config[firewall-ipv4-lan-dmz-outbound]> service_name default_services FTP
security-config[firewall-ipv4-lan-dmz-outbound]> action ALWAYS_ALLOW
security-config[firewall-ipv4-lan-dmz-outbound]> lan_users group_wise GROUP4
security-config[firewall-ipv4-lan-dmz-outbound]> dmz_users ADDRESS_RANGE
security-config[firewall-ipv4-lan-dmz-outbound]> dmz_user_start_ip 176.14.2.30
security-config[firewall-ipv4-lan-dmz-outbound]> dmz_user_end_ip 176.14.2.79
security-config[firewall-ipv4-lan-dmz-outbound]> log Never
security-config[firewall-ipv4-lan-dmz-outbound]> save
Related show command: show security firewall ipv4 setup lan_dmz
security firewall ipv4 edit_rule lan_dmz outbound <row id>
This command configures an existing IPv4 LAN DMZ outbound firewall rule. After you have
issued the security firewall ipv4 edit_rule lan_dmz outbound command to
specify the row to be edited (for row information, see the output of the
show security firewall
ipv4 setup lan_dmz
command), you enter the security-config [firewall-ipv4-lan-dmz-outbound]
mode. You can then edit one keyword and associated parameter or associated keyword at a
time in the order that you prefer. However, note that the setting of the action keyword
determines which other keywords and parameters you can apply to a rule.
Logging
log NEVER or ALWAYS Specifies whether logging is
disabled or enabled.
Step 1 Format security firewall ipv4 edit_rule lan_dmz outbound <row id>
Mode security
Step 2 Format service_name {default_services <default service name> |
{custom_services <custom service name>}
action {ALWAYS_BLOCK | ALWAYS_ALLOW |
BLOCK_BY_SCHEDULE_ELSE_ALLOW {schedule {Schedule1 |
Schedule2 | Schedule3}} | ALLOW_BY_SCHEDULE_ELSE_BLOCK
{schedule {Schedule1 | Schedule2 | Schedule3}}}
Keyword (might consist of two
separate words)
Associated Keyword to Select or
Parameter to Type
Description