NETGEAR ProSAFE SRX5308 - Page 163

Security Mode Configuration Commands
163
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Related show command: show security firewall attack_checks setup ipv4
security firewall attack_checks igmp configure
This command enables or disables multicast pass-through by enabling or disabling the IGMP
proxy for IPv4 traffic. After you have issued the security firewall attack_checks
igmp configure command, you enter the security-config [igmp] mode, and then you can
enable or disable the IGMP proxy.
Related show command: show security firewall attack_checks igmp
security firewall attack_checks vpn_passthrough configure
This command configures VPN pass-through for IPv4 traffic. After you have issued the
security firewall attack_checks vpn_passthrough configure command, you
enter the security-config [vpn-passthrough] mode, and then you can configure one keyword
and associated parameter or associated keyword at a time in the order that you prefer.
Command example:
SRX5308> security firewall attack_checks vpn_passthrough configure
security-config[vpn-passthrough]> ipsec_enable Y
Step 1 Format security firewall attack_checks igmp configure
Mode security
Step 2 Format enable_igmp_proxy {Y | N}
Mode security-config [igmp]
Step 1 Format security firewall attack_checks vpn_passthrough configure
Mode security
Step 2 Format ipsec_enable {Y | N}
l2tp_enable {Y | N}
pptp_enable {Y | N}
Mode security-config [vpn-passthrough]
Keyword Associated Keyword
to Select
Description
ipsec_enable Y or N Enables or disables IPSec pass-through.
l2tp_enable Y or N Enables or disables L2TP pass-through.
pptp_enable Y or N Enables or disables PPTP pass-through.