NETGEAR ProSAFE SRX5308 - Page 190

System Mode Configuration Commands
190
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
SRX5308> system remote_management telnet configure
system-config[telnet]> ip_version IPv6
system-config[telnet]> enable_ipv6 Y
system-config[telnet]> access_type6 IP_Range
system-config[telnet]> from_address6 FEC0::3001
system-config[telnet]> end_address6 FEC0::3100
system-config[telnet]> save
Related show command: show system remote_management setup
access_type6 Everyone, IP_Range, or
To_this_PC_only
Specifies the type of access:
• Everyone. Enables access to all IP addresses. You
do not need to configure any IP address.
• IP_Range. Enables access to a range of IP
addresses. You also need to configure the
from_address6 and to_address6 keywords and
associated parameters.
• To_this_PC_only. Enables access to a single IP
address. You also need to configure the
only_this_pc_ip6 keyword and associated
parameter.
from_address6 ipv6-address The start IP address if you have set the
access_type6 keyword to IP_Range.
to_address6 ipv6-address The end IP address if you have set the
access_type6 keyword to IP_Range.
only_this_pc_ip6 ipaddress The single IP address if you have set the
access_type6 keyword to To_this_PC_only.
Keyword Associated Keyword to
Select or Parameter to Type
Description